Introduction
We make far infrared heaters that slide right into your existing setup. Think of them as the direct replacement for your industrial heating elements, but better. These quartz tube lamps are all about delivering a concentrated blast of radiant heat—right where you need it. They’re built for one thing: getting a specific spot hot, and fast.
What’s Inside
Here’s the secret sauce. Inside each heater is a halogen-filled quartz tube. It keeps the filament steady, even when things are cranked up to serious temperatures. We match the wattage and voltage to the tube length, so you get the exact heat density you’re after. A 400V supply is often the go-to because it packs the power you need into a small space. And the length? We size it to match the heating zone in your machine. The result? Heat goes exactly where you want it, and you don’t waste a single watt.
Built to Last
The quartz tube is tough. It takes thermal shock without cracking, which is exactly what you need in a tough industrial environment. And the halogen cycle? That’s what keeps the heat output steady over the life of the lamp. No fading. No surprises. We also coat the tube to focus the infrared energy right where it matters most—on the workpiece. This means plastics and coatings absorb the heat better, and your process runs smoother. Then there’s the R7s connector. It’s a simple two-terminal setup that snaps in and carries the current without a fuss. For you, that means a drop-in replacement. No rewiring. No custom fittings. Just swap it in and get back to work.
Where It Shines
You’ll find these heaters in places where fast, even heating is the name of the game. PET blowing. Plastic thermoforming. Drying lines. They warm up fast. Seriously fast. But that power comes with a catch: your machine needs to be ready for it.
The Fine Print
High power in a small tube means you have to manage the heat. It’s non-negotiable. Make sure your cooling and airflow are up to the task. Size your blower and heat shielding to match the wattage. If you don’t, you’re just asking for the component to burn out sooner than it should.